News center
Your present position:Home >> News Center
The cautions of enamel reaction kettle no-load test run
Addtime：2016-10-27 08:44:07 Print
Enamel reaction kettle due to its special performance by the users of all ages, here small make up of enamel reaction kettle no-load commissioning and you talk about matters needing attention, the following is the small make up finishing about its content, please look down.
1, motor, reducer, normal temperature, bearing temperature shall not exceed 70 ℃, sliding bearing temperature shall not exceed 65 ℃;
2, enamel reaction kettle inside lining leakage, bulge;In coil, pressure pipe, casing thermometer should be solid and reliable;
Each part of the 3, turn the light, lubrication requirements;
4, no-load start-up, commissioning shall be run outside of water 4 ~ 8 h, feeding trial shipment should be no less than a reaction cycle;
5, enamel reaction kettle of reliable sealing, leakage conform to the requirements, the seal of the momentum should not be more than a specified value.
We will, as always, for the majority of users to provide more fine products and higher quality of service, create beautiful future together and efforts to forge ahead!
1, motor, reducer, normal temperature, bearing temperature shall not exceed 70 ℃, sliding bearing temperature shall not exceed 65 ℃;
2, enamel reaction kettle inside lining leakage, bulge;In coil, pressure pipe, casing thermometer should be solid and reliable;
Each part of the 3, turn the light, lubrication requirements;
4, no-load start-up, commissioning shall be run outside of water 4 ~ 8 h, feeding trial shipment should be no less than a reaction cycle;
5, enamel reaction kettle of reliable sealing, leakage conform to the requirements, the seal of the momentum should not be more than a specified value.
We will, as always, for the majority of users to provide more fine products and higher quality of service, create beautiful future together and efforts to forge ahead!